I did think of using a linear supply, but trying to cram it into the PC case might be a bit tight.
Cheers for fixing the typo.
I did think of using a linear supply, but trying to cram it into the PC case might be a bit tight.
Cheers for fixing the typo.
Location: Troon
Posts: 2,476
I'm tony.
Anybody running a t amp off a battery?
I have a spare car battery and was wondering if I could run the bantum off it.Would i need to run a fuse in line or just connect it directly?
I recommend taking the battery out of the car first.
Jerry
Hifi: IPL transmission line floorstanding speakers, Squeezebox Touch, Denafrips Ares 11 DAC, DCB1 Pre-amplifier, Croft Series 7 power amp.
Custom Hifi cables HA10SE headphone amplifier and Hifiman HE-400 headphones.
AV system: LG 55B7, Denon AVR -x2300w receiver, Quad 12L (front) 11c Centre and 11L rear . Velodyne DD15 subwoofer.
wha-hey!
AC POWER
Hardwired 10kVA balanced mains powering entire system
AMPS
Meridian 557 power Amp (Modded) / PS Audio BHK Preamp (Modded)
SPEAKERS
Wharfedale Evo 4.4
DAC
PS Audio Directstream (Modded)
TURNTABLE
Pro-Ject X8 balanced output via XLR / Ortofon Quintet Blue cartridge
PHONOSTAGE
Pro-Ject DS3 B balanced Input (TT and Phonostage powered by Pro-Ject Power box RS2 linear psu)
DIGITAL
OPPO 203 (Modded: Linear PSU, i2s output to Dac) - Roon Endpoint, HDMI input used for all things Streaming/ PS5 /AppleTV ... also good for movies apparently?
MUSIC PLAYBACK
Tweaked AP-Linux based Roon Server into Oppo 203 as Roon endpoint
Ipad Roon Remote.
Apple Music/ YouTube via AppleTV, fed to Dac via Oppo HDMI input/i2s output to Dac.
SPEAKER CABLES
Biwired: Duelund DCA10GA (Bass) Duelund DCA16GA (mid & treble) Duelund 12DCA used as jumpers (On "Blackcat Cable" Chris Sommivigo's advice - yup, even with biwire it sounds better - and it does)
INTERCONNECTS
All Balanced: Ghost+ recording studio XLR cables
Location: Troon
Posts: 2,476
I'm tony.
Jerry
Hifi: IPL transmission line floorstanding speakers, Squeezebox Touch, Denafrips Ares 11 DAC, DCB1 Pre-amplifier, Croft Series 7 power amp.
Custom Hifi cables HA10SE headphone amplifier and Hifiman HE-400 headphones.
AV system: LG 55B7, Denon AVR -x2300w receiver, Quad 12L (front) 11c Centre and 11L rear . Velodyne DD15 subwoofer.
Tony, make sure you put a fuse between the battery & amplifier I'd suggest a 5Amp fast blow type which will allow the amp to deal with transients into low impedance loads.
Car batteries are quite happy to serve up 1KA or over 10,000W of power for a short while, not good for equipment if it happens to go wrong explosion.gif
Bests, Mark
"We must believe in free will. We have no choice" Isaac Bashevis Singer
I ran my Trends TA 10.1 from an SLA that I charged with a motorbike charger...
I thought it sounded very slightly smoother on the battery, but the difference was minimal at best. I never had a problem with noise from this amp despite using sensitive speakers.
They swim... the mark of Satan is upon them. They must hang.
FLAC / WDTV Live / Cambridge Audio / Tannoy VX12
AC POWER
Hardwired 10kVA balanced mains powering entire system
AMPS
Meridian 557 power Amp (Modded) / PS Audio BHK Preamp (Modded)
SPEAKERS
Wharfedale Evo 4.4
DAC
PS Audio Directstream (Modded)
TURNTABLE
Pro-Ject X8 balanced output via XLR / Ortofon Quintet Blue cartridge
PHONOSTAGE
Pro-Ject DS3 B balanced Input (TT and Phonostage powered by Pro-Ject Power box RS2 linear psu)
DIGITAL
OPPO 203 (Modded: Linear PSU, i2s output to Dac) - Roon Endpoint, HDMI input used for all things Streaming/ PS5 /AppleTV ... also good for movies apparently?
MUSIC PLAYBACK
Tweaked AP-Linux based Roon Server into Oppo 203 as Roon endpoint
Ipad Roon Remote.
Apple Music/ YouTube via AppleTV, fed to Dac via Oppo HDMI input/i2s output to Dac.
SPEAKER CABLES
Biwired: Duelund DCA10GA (Bass) Duelund DCA16GA (mid & treble) Duelund 12DCA used as jumpers (On "Blackcat Cable" Chris Sommivigo's advice - yup, even with biwire it sounds better - and it does)
INTERCONNECTS
All Balanced: Ghost+ recording studio XLR cables
Location: Troon
Posts: 2,476
I'm tony.